8-12
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 8 Controlling Mesh Access Points
Adding Mesh Access Points to the Mesh Network
Using the GUI to Add MAC Addresses of Mesh Access Points to the Controller Filter List
Using the controller GUI, follow these steps to add a MAC filter entry for the access point on the
controller.
Step 1 Click Security > AAA > MAC Filtering to open the MAC Filtering page (see Figure 8-7).
Figure 8-7 MAC Filtering Page
Step 2 Click New to open the MAC Filters > New page (see Figure 8-8).
Figure 8-8 MAC Filters > New Page
Step 3 In the MAC Address field, enter the MAC address of the mesh access point.
Note For 1522 and 1524 outdoor mesh access points, enter the BVI MAC address of the mesh access
point into the controller as a MAC filter. For 1130 and 1240 indoor mesh access points, enter the
Ethernet MAC address. If the required MAC address does not appear on the exterior of the mesh
access point, enter the following command from the access point console to determine the BVI
and Ethernet MAC addresses: sh int | i Hardware.
Step 4 From the Profile Name drop-down box, choose Any WLAN.
To Next Page
Loading...
Need help?
General
