Contents
vii
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Using the CLI to View an Access Point’s Multicast Client Table 4-39
Configuring Client Roaming 4-40
Intra-Controller Roaming 4-40
Inter-Controller Roaming 4-40
Inter-Subnet Roaming 4-40
Voice-over-IP Telephone Roaming 4-40
CCX Layer 2 Client Roaming 4-41
Using the GUI to Configure CCX Client Roaming Parameters 4-42
Using the CLI to Configure CCX Client Roaming Parameters 4-43
Using the CLI to Obtain CCX Client Roaming Information 4-43
Using the CLI to Debug CCX Client Roaming Issues 4-44
Configuring IP-MAC Address Binding 4-44
Configuring Quality of Service 4-45
Configuring Quality of Service Profiles 4-45
Using the GUI to Configure QoS Profiles 4-45
Using the CLI to Configure QoS Profiles 4-47
Configuring Quality of Service Roles 4-48
Using the GUI to Configure QoS Roles 4-48
Using the CLI to Configure QoS Roles 4-50
Configuring Voice and Video Parameters 4-52
Call Admission Control 4-52
Bandwidth-Based CAC 4-52
Load-Based CAC 4-52
Expedited Bandwidth Requests 4-53
U-APSD 4-54
Traffic Stream Metrics 4-54
Using the GUI to Configure Voice Parameters 4-54
Using the GUI to Configure Video Parameters 4-56
Using the GUI to View Voice and Video Settings 4-57
Using the CLI to Configure Voice Parameters 4-62
Using the CLI to Configure Video Parameters 4-63
Using the CLI to View Voice and Video Settings 4-64
Configuring EDCA Parameters 4-67
Using the GUI to Configure EDCA Parameters 4-67
Using the CLI to Configure EDCA Parameters 4-68
Configuring Cisco Discovery Protocol 4-69
Using the GUI to Configure Cisco Discovery Protocol 4-72
Using the GUI to View Cisco Discovery Protocol Information 4-73
Using the CLI to Configure Cisco Discovery Protocol 4-77