EasyManuals Logo

Cisco 7000 Hardware Installation And Maintenance

Cisco 7000
319 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #220 background imageLoading...
Page #220 background image
5-216 Cisco 7000 Hardware Installation and Maintenance
Installing and Configuring Processor Modules
MIP Configurations
Following are procedures for configuring T1 and E1 interfaces on the MIP.
Configuring the Interfaces
If you installed a new MIP or if you want to change the configuration of an existing controller, you
must enter the configuration mode. If you replaced the MIP that was previously configured, the
system will recognize the new MIP and bring it up in the existing configuration.
After you verify that the new MIP is installed correctly (the enabled LED is on), use the
privileged-level configure command to configure the new MIP controller. Be prepared with the
information you will need, such as the following:
T1 and/or E1 information, for example clock source (for T1), line code, and framing type
Channel-group information and timeslot mapping
Protocols and encapsulations you plan to use on the new interfaces
Internet protocol (IP) addresses if you will configure the interfaces for IP routing
Whether the new interface will use bridging
Refer to the Router Products Configuration Guide and Router Products Command Reference
publications for a summary of the configuration options available and instructions for configuring
the MIP controller.
Configuring Jumper J6 on the E1 Port Adapter
By default, channelized E1 port adapters are set with capacitive coupling between the receive (Rx)
shield and chassis ground. This provides direct current (DC) isolation between the chassis and
external devices, as stated in the G.703 specification. Jumper J6 controls this function. To make
changes, remove the E1 port adapter from the mother board, place one of the spare jumpers on J6
pins one and two or pins two and three (refer to Table 5-11), and replace the port adapter on the
motherboard. Pin 1 of J6 is designated with a square. (See Figure 5-20.)
For procedures on removing the E1 port adapter from the MIP, refer to the section “Removing and
Replacing MIP Port Adapters” in this chapter.

Table of Contents

Other manuals for Cisco 7000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7000 and is the answer not in the manual?

Cisco 7000 Specifications

General IconGeneral
Product TypeSwitch
Model7000
CategorySwitch
PortsVaries by configuration
Power SupplyRedundant power supplies supported
ManagementSNMP, CLI

Related product manuals