Cisco 7000 Hardware Installation And Maintenance

5-220 Cisco 7000 Hardware Installation and Maintenance
Installing and Configuring Processor Modules
Step 7 At the prompt, specify the interface, serial, slot, applique, and channel-group to modify.
Router(config-controller)# int serial 4/1:0
Step 8 At the prompt, assign an IP address and subnet mask to the interface with the ip address
configuration subcommand as in the following example:
Router(config-if)# ip address 1.1.15.1 255.255.255.0
Router(config-if)#
Step 9 Add any additional configuration subcommands required to enable routing protocols and
adjust the interface characteristics.
Step 10 After including all of the configuration subcommands, to complete the configuration, enter
^Z (hold down the Control key while you press Z) to exit the configuration mode.
Step 11 Write the new configuration to memory as follows:
Router# write memory
The system will display an OK message when the configuration is stored.
Step 12 Exit the privileged level and return to the user level by entering disable at the prompt as
follows:
Router# disable
Router>
Step 13 Proceed to the following section to check the interface configuration with show commands.
E1 Configuration
The following steps describe a basic E1 configuration. Press the Return key after each step.
Step 1 At the privileged-mode prompt, enter the configuration mode and specify that the console
terminal will be the source of the configuration subcommands as follows:
Router# conf t
Enter configuration commands, one per line. End with CNTL/Z. Router(config)#
Step 2 At the prompt, specify the controller to configure by entering the subcommand cont,
followed by e1, and slot/applique (interface processor slot number/applique). The example
that follows is for the MIP in interface processor slot 4, applique 1:
Router(config)# cont e1 4/1
Step 3 At the prompt, specify the framing type.
Router(config-controller)# framing crc4
Step 4 At the prompt, specify the linecode format.
Router(config-controller)# linecode hdb3
Router(config-controller)#
%CONTROLLER-3-UPDOWN: Controller E1 4/1, changed state to up
Router(config-controller)#

Cisco 7000 Specifications

General

Product Type	Switch
Model	7000
Category	Switch
Ports	Varies by configuration
Power Supply	Redundant power supplies supported
Management	SNMP, CLI