Cisco 7906G Administration Guide

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Network Configuration Menu
4-10
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
TFTP Server 2 Optional backup TFTP server that
the phone uses if the primary TFTP
server is unavailable.
If neither the primary TFTP server
nor the backup TFTP server is
listed in the CTL file on the phone,
you must unlock the CTL file
before you can save changes to the
TFTP Server 2 option. In this case,
the phone will delete the CTL file
when you save changes to the
TFTP Server 2 option.
For information about the CTL file,
refer to
Cisco
Unified CallManager
Security Guide. For information
about unlocking the CTL file, see
to the
“CTL File Screen” section
on page 4-33.
1. Unlock the CTL file, if necessary.
2. Unlock network configuration options.
3. Enter an IP address for the TFTP Server 1
option.
4. Scroll to the TFTP Server 2 option, press
the Edit softkey, and then enter a new
backup TFTP server IP address.
5. Press the Validate softkey, and then press
the Save softkey.
Default Router 1
Default Router 2
Default Router 3
Default Router 4
Default Router 5
Default router used by the phone
(Default Router 1) and optional
backup routers (Default Router
2–5).
1. Unlock network configuration options.
2. Set the DHCP Enabled option to No.
3. Scroll to the appropriate Default Router
option, press the Edit softkey, and then
enter a new router IP address.
4. Press the Validate softkey.
5. Repeat Steps 3 and 4 as needed to assign
backup routers.
6. Press the Save softkey.
Table 4-2 Network Configuration Menu Options (continued)
Option Description To Change

Cisco 7906G Specifications

General

Brand	Cisco
Model	7906G
Category	IP Phone
Language	English