Cisco Catalyst 3560X-24P

2-492
Catalyst 3750-X and 3560-X Switch Command Reference
OL-21522-02
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
sdm prefer
Table 2-24 lists the approximate number of each resource supported in each of the dual IPv4-and
IPv6templates for a switch.
Note On switches running the LAN base feature set, routing values shown in all templates are not valid.
Examples This example shows how to configure the access template on a switch:
Switch(config)# sdm prefer access
Switch(config)# exit
Ta b l e 2-23 Approximate Number of Feature Resources Allowed by IPv4 Templates
Resource Access Default Routing VLAN
Unicast MAC addresses 4 K 6 K 3 K 12 K
Internet Group Management Protocol
(IGMP) groups and multicast routes
1 K 1 K 1 K 1 K
Unicast routes 6 K 8 K 11 K 0
• Directly connected hosts 4 K 6 K 3 K 0
• Indirect routes 2 K 2 K 8 K 0
Policy-based routing access control entries
(ACEs)
0.5 K 0 0.5 K 0
Quality of service (QoS) classification ACEs 0.5 K 0.5 K 0.5 K 0.5 K
Security ACEs 2 K 1 K 1 K 1 K
VLANs 1 K 1 K 1 K 1 K
Ta b l e 2-24 Approximate Feature Resources Allowed by Dual IPv4-IPv6 Templates
Resource Default Routing VLAN
Unicast MAC addresses 2 K 1.5 K 8 K
IPv4 IGMP groups and multicast routes 1 K 1 K 1 K for IGMP groups
0 for multicast routes
Total IPv4 unicast routes: 3 K 2.75 K 0
• Directly connected IPv4 hosts 2 K 1.5 K 0
• Indirect IPv4 routes 1 K 1.25 K 0
IPv6 multicast groups 1 K 1 K 1 K
Directly connected IPv6 addresses 2 K 1.5 K 0
Indirect IPv6 unicast routes 1 K 1.25 K 0
IPv4 policy-based routing ACEs 0 0.25 K 0
IPv4 or MAC QoS ACEs (total) 0.5 K 0.5 K 0.5 K
IPv4 or MAC security ACEs (total) 1 K 0.5 K 1 K
IPv6 security ACEs 1 K 1 K 0.5 K