44-118
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 44 Configuring 802.1X Port-Based Authentication
Cisco IOS Security Features in Cisco IOS XE 3.1.0 SG Release
Switch(config)# epm logging
Switch# clear dot1x all
Switch#
*May 15 08:31:26.561: %EPM-6-POLICY_REQ: IP=100.0.0.222| MAC=0000.0000.0001|
AUDITSESID=0A050B2C000000030004956C| AUTHTYPE=DOT1X|
EVENT=REMOVE
*May 15 08:31:26.581: %AUTHMGR-5-START: Starting 'dot1x' for client (0000.0000.0001) on
Interface Fa9/25
*May 15 08:31:26.681: %DOT1X-5-SUCCESS: Authentication successful for client
(0000.0000.0001) on Interface Fa9/25
*May 15 08:31:26.681: %AUTHMGR-7-RESULT: Authentication result 'success' from 'dot1x' for
client (0000.0000.0001) on Interface Fa9/25
Example 2
Switch# conf terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# epm logging
Switch(config)# int f9/25
Switch(config-if)# shut
Switch(config-if)# no shut
*May 15 08:41:56.329: %EPM-6-IPEVENT: IP=100.0.0.222| MAC=0000.0000.0001|
AUDITSESID=0A050B2C0000026108FB7924| AUTHTYPE=DOT1X|
EVENT=IP-RELEASE
*May 15 08:41:56.333: %EPM-6-IPEVENT: IP=100.0.0.222| MAC=0000.0000.0001|
AUDITSESID=0A050B2C0000026108FB7924| AUTHTYPE=DOT1X|
EVENT=IP-WAIT
Cisco IOS Security Features in Cisco IOS XE 3.1.0 SG Release
This document provides a list of security software features that are supported in Cisco IOS XE 3.1.0SG.
Links to the feature documentation are included.
Feature guides may contain information about more than one feature. To find information about a
specific feature within a feature guide, see the Feature Information table at the end of the guide.
Feature guides document features that are supported on many different software releases and platforms.
Your Cisco software release or platform may not support all the features documented in a feature guide.
See the Feature Information table at the end of the feature guide for information about which features in
that guide are supported in your software release. Use Cisco Feature Navigator to find information about
platform support and Cisco software image support. To access Cisco Feature Navigator, go to
http://www.cisco.com/go/cfn. An account on Cisco.com is not required.
Role-Based Access Control CLI Commands
http://www.cisco.com/en/US/docs/ios/sec_user_services/configuration/guide/sec_role_base_cli.html
Authentication Proxy Accounting for HTTP
http://www.cisco.com/en/US/docs/ios/sec_user_services/configuration/guide/sec_cfg_authen_prxy.htm
l
Enhanced Password Security
http://www.cisco.com/en/US/docs/ios/sec_user_services/configuration/guide/sec_cfg_sec_4cli.html
To Next Page
Loading...
