Cisco Catalyst 4500 Series - Configuring Copp for Data Plane and Management Plane Traffic

48-5
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 48 Configuring Control Plane Policing and Layer 2 Control Packet QoS
Configuring Control Plane Policing
police 32000 bps 1000 byte conform-action transmit exceed-action drop
Class system-cpp-sstp
Class system-cpp-cgmp
Class system-cpp-ospf
Class system-cpp-hsrpv2
Class system-cpp-igmp
Class system-cpp-pim
Class system-cpp-all-systems-on-subnet
Class system-cpp-all-routers-on-subnet
Class system-cpp-ripv2
Class system-cpp-ip-mcast-linklocal
Class system-cpp-dhcp-cs
Class system-cpp-dhcp-sc
Class system-cpp-dhcp-ss
Switch#
Configuring CoPP for Data Plane and Management Plane Traffic
To configure CoPP for data plane and management plane traffic, perform this task:
Command Purpose
Step 1
Switch(config)# qos
(Optional) Enables QoS globally.
Step 2
Switch(config)#
macro global apply system-cpp
(Optional) Attaches the system-cpp-policy policy
map to the control plane.