29-4
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 29 Configuring LLDP, LLDP-MED, and Location Service
Configuring LLDP and LLDP-MED, and Location Service
• Slot, port, and port-type
• Client’s MAC address
• Client’s IP address
• 802.1X username if applicable
• Device category is specified as a wired station
• State is specified as Connected
• Serial number, UDI
• Model number
• Software version
• VLAN ID and VLAN name
Depending on the device capabilities, the switch obtains this client information at link down:
• Slot and port that was disconnected
• Client’s MAC address
• Client’s IP address
• 802.1X username if applicable
• Device category is specified as a wired station
• State is specified as Disconnected
• Serial number, UDI
• Model number
• Software version
• VLAN ID and VLAN name
If an administrator changes a location address at the switch, the information is reported to the MSE. The
switch sends a NMSP location notification message that identifies the list of ports affected by the change
and the changed address information.
Configuring LLDP and LLDP-MED, and Location Service
This section contains this configuration information:
• Default LLDP Configuration, page 29-5
• Configuring LLDP Characteristics, page 29-5
• Disabling and Enabling LLDP Globally, page 29-6
• Disabling and Enabling LLDP on an Interface, page 29-7
• Configuring LLDP-MED TLVs, page 29-9
• Configuring Network-Policy Profile, page 29-10
• Configuring LLDP Power Negotiation, page 29-11
• Configuring Location TLV and Location Service, page 29-12
• Monitoring and Maintaining LLDP, LLDP-MED, and Location Service, page 29-14
To Next Page
Loading...
