Cisco Catalyst 4500 Series - Power-On Self-Test Results

68-13
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 68 Performing Diagnostics
Traffic: L3 Looopback ...
Test Results: Pass
Traffic: L2 Loopback ...
Test Results: Pass
post done
Exiting to ios...
Power-On Self-Test Results
The following topics are discussed:
• Sample Display of the POST on an Active Supervisor Engine, page 68-13
• Sample Display of the POST on a Standby Supervisor Engine, page 68-16
Sample Display of the POST on an Active Supervisor Engine
Examples include:
• Supervisor Engine 6-E and Supervisor Engine 6L-E, page 68-13
• Supervisor Engine 7-E and Supervisor Engine 7L-E, page 68-15
Supervisor Engine 6-E and Supervisor Engine 6L-E
Switch# show diagnostic result module 5 detail
Current bootup diagnostic level: minimal
module 5: SerialNo : JAE1213CK36
Overall Diagnostic Result for module 5 : PASS
Diagnostic level at card bootup: minimal
Test results: (. = Pass, F = Fail, U = Untested)
___________________________________________________________________________
1) supervisor-bootup ---------------> .
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 1
Last test testing type ------> n/a
Last test execution time ----> Jul 21 2011 13:35:55
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Jul 21 2011 13:35:55
Total failure count ---------> 0
Consecutive failure count ---> 0
Power-On-Self-Test Results for ACTIVE Supervisor
prod: WS-X45-SUP6-E part: 73-10597-06 serial: JAE1213CK36
Power-on-self-test for Module 5: WS-X45-SUP6-E
CPU Subsystem Tests ...
seeprom: Pass