Cisco Catalyst 4500 Series - Sample Display of the POST on a Standby Supervisor Engine

68-16
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 68 Performing Diagnostics
Last test pass time ---------> Jul 21 2011 20:16:56
Total failure count ---------> 0
Consecutive failure count ---> 0
Slot Ports Card Type Diag Status Diag Details
---- ----- -------------------------------------- ---------------- ------------
3 4 Sup 7-E 10GE (SFP+), 1000BaseX (SFP) Skipped Packet memory
Detailed Status
---------------
. = Pass U = Unknown
L = Loopback failure S = Stub failure
P = Port failure
E = SEEPROM failure G = GBIC integrity check failure
Ports 1 2 3 4
. . . .
___________________________________________________________________________
3) stub-rx-errors ------------------> .
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 2
Last test testing type ------> Health Monitoring
Last test execution time ----> Jul 21 2011 20:18:57
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Jul 21 2011 20:18:57
Total failure count ---------> 0
Consecutive failure count ---> 0
___________________________________________________________________________
4) supervisor-rx-errors ------------> .
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 2
Last test testing type ------> Health Monitoring
Last test execution time ----> Jul 21 2011 20:18:57
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Jul 21 2011 20:18:57
Total failure count ---------> 0
Consecutive failure count ---> 0
Switch#
Sample Display of the POST on a Standby Supervisor Engine
Example include:
• Supervisor Engine 6-E and Supervisor Engine 6L-E, page 68-16
• Supervisor Engine 7-E and Supervisor Engine 7L-E, page 68-18
Supervisor Engine 6-E and Supervisor Engine 6L-E
Switch# show diagnostic result module 6 detail
Current bootup diagnostic level: minimal
module 6: SerialNo :