EasyManua.ls Logo

Cisco Catalyst 4500 Series - POST Result Example

Cisco Catalyst 4500 Series
1610 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
68-11
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 68 Performing Diagnostics
WS-C4948G-10GE
ME-4924-10GE
WS-X45-SUP6-E
WS-X45-SUP6L-E
WS-X45-SUP7-E
WS-X45-SUP7L-E
The POST results are indicated with a period (.) or a Pass for Pass, an F for a Fail and a U for Untested.
POST Result Example
For all the supervisor engines, POST performs CPU, traffic, system, system memory, and feature tests.
For CPU tests, POST verifies appropriate activity of the supervisor engine SEEPROM, temperature
sensor, and Ethernet end-of-band channel (EOBC), when used.
The following example illustrates the output of a CPU subsystem test:
[..]
Cpu Subsystem Tests ...
seeprom: . temperature_sensor: . eobc: .
[..]
For traffic tests, the POST sends packets from the CPU to the switch. These packets loop several times
within the switch core and validate the switching, the Layer 2 and the Layer 3 functionality. To isolate
the hardware failures accurately, the loop back is done both inside and outside the switch ports.
The following example shows the output for a Supervisor Engine 6-E and Supervisor Engine 6L-E:
Switch# show diagnostic result module 3 detail
module 3: SerialNo : XXXXXXXXXXX
Overall diagnostic result: PASS
Test results: (. = Pass, F = Fail, U = Untested)
___________________________________________________________________________
1) supervisor-bootup --------------->
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 1
Last test execution time ----> Oct 01 2007 17:37:04
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Oct 01 2007 17:37:04
Total failure count ---------> 0
Consecutive failure count ---> 0
Power-On-Self-Test Results for ACTIVE Supervisor
prod: WS-X45-SUP6-E part: XXXXXXXXX serial: XXXXXXXXXX
Power-on-self-test for Module 3: WS-X45-SUP6-E
Test Status: (. = Pass, F = Fail, U = Untested)
CPU Subsystem Tests ...
seeprom: Pass
Traffic: L3 Loopback ...
Test Results: Pass

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Related product manuals