Cisco Catalyst 4500 Series Configuration Guide

3-13
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 3 Configuring the Switch for the First Time
Controlling Access to Privileged EXEC Commands
.
ip default-gateway 172.20.52.35
ip classless
ip route 171.20.5.3 255.255.255.255 Vlan1
no ip http server
!
!
x25 host z
!
line con 0
transport input none
line vty 0 4
exec-timeout 0 0
password lab
login
transport input lat pad dsipcon mop telnet rlogin udptn nasi
!
end
Switch#
Controlling Access to Privileged EXEC Commands
The procedures in these sections let you control access to the system configuration file and privileged
EXEC commands:
• Setting or Changing a Static enable Password, page 3-13
• Using the enable password and enable secret Commands, page 3-14
• Setting or Changing a Privileged Password, page 3-14
• Controlling Switch Access with TACACS+, page 3-15
• Encrypting Passwords, page 3-22
• Configuring Multiple Privilege Levels, page 3-23
Setting or Changing a Static enable Password
To set or change a static password that controls access to the enable mode, enter this command:
This example shows how to configure an enable password as lab:
Switch# configure terminal
Switch(config)# enable password lab
Switch(config)#
For instructions on how to display the password or access level configuration, see the “Displaying the
Password, Access Level, and Privilege Level Configuration” section on page 3-24.
Command Purpose
Switch(config)# enable password password
Sets a new password or changes an existing
password for the privileged EXEC mode.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E