Cisco Catalyst 4500 Series Configuration Guide

48-9
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 48 Configuring Control Plane Policing and Layer 2 Control Packet QoS
Monitoring CoPP
Monitoring CoPP
You can enter the show policy-map control-plane command to develop site-specific policies, to monitor
statistics for the control plane policy, and to troubleshoot CoPP. This command displays dynamic
information about the actual policy applied, including rate information and the number of bytes (and
packets) that conformed or exceeded the configured policies both in hardware and in software.
The output of the show policy-map control-plane command is similar to the following:
Switch# show policy-map control-plane
Control Plane
Service-policy input: system-cpp-policy
Class-map: system-cpp-dot1x (match-all)
0 packets
Match: access-group name system-cpp-dot1x
Class-map: system-cpp-bpdu-range (match-all)
0 packets
Match: access-group name system-cpp-bpdu-range
* Class-map: system-cpp-cdp (match-all)
160 packets
Match: access-group name system-cpp-cdp
** police: Per-interface
Conform: 22960 bytes Exceed: 0 bytes
*
Class-map: system-cpp-sstp (match-all)
0 packets
Match: access-group name system-cpp-sstp
Class-map: system-cpp-cgmp (match-all)
0 packets
Match: access-group name system-cpp-cgmp
Class-map: system-cpp-hsrpv2 (match-all)
0 packets
Match: access-group name system-cpp-hsrpv2
Class-map: system-cpp-ospf (match-all)
0 packets
Match: access-group name system-cpp-ospf
Class-map: system-cpp-igmp (match-all)
0 packets
Match: access-group name system-cpp-igmp
Class-map: system-cpp-pim (match-all)
0 packets
Match: access-group name system-cpp-pim
Class-map: system-cpp-all-systems-on-subnet (match-all)
0 packets
Match: access-group name system-cpp-all-systems-on-subnet
Class-map: system-cpp-all-routers-on-subnet (match-all)
0 packets
Match: access-group name system-cpp-all-routers-on-subnet
Class-map: system-cpp-ripv2 (match-all)
0 packets

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E