Cisco Catalyst 4500 Series - Determining MIB Support for Cisco IOS Releases

To Next Page

To Previous Page

CHAPTER

70-1

Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG

OL-25340-01

Configuring MIB Support

This chapter describes how to configure SNMP and MIB support for the Cisco 4500 series switch. It

includes the following sections:

• Determining MIB Support for Cisco IOS Releases, page 70-1

• Using Cisco IOS MIB Tools, page 70-2

• Downloading and Compiling MIBs, page 70-2

• Enabling SNMP Support, page 70-4

Note For complete syntax and usage information for the switch commands used in this chapter, first look at

the Cisco Catalyst 4500 Series Switch Command Reference and related publications at this location:

http://www.cisco.com/en/US/products//hw/switches/ps4324/index.html

If the command is not found in the Catalyst 4500 Series Switch Command Reference, it will be found in

the larger Cisco IOS library. Refer to the Catalyst 4500 Series Switch Cisco IOS Command Reference

and related publications at this location:

http://www.cisco.com/en/US/products/ps6350/index.html

Determining MIB Support for Cisco IOS Releases

To determine which MIBs are included in the Cisco IOS release running on the Cisco 4500 series switch,

follow these steps:

Step 1 Go to the Cisco MIBs Support page:

http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

Step 2 Under Cisco Access Products, select a Cisco 4500 switch to display a list of MIBs supported on the

Cisco 4500 switches.

Step 3 Scroll through the list to find the release you are interested in.

Other manuals for Cisco Catalyst 4500 Series