EasyManuals Logo

Cisco Catalyst 4500 Series Configuration Guide

Cisco Catalyst 4500 Series
1610 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #695 background imageLoading...
Page #695 background image
28-3
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 28 Configuring CDP
Configuring CDP
Enabling CDP on an Interface
To enable CDP on an interface, use this command:
This example shows how to enable CDP on Fast Ethernet interface 5/1:
Switch(config)# interface fastethernet 5/1
Switch(config-if)# cdp enable
This example shows how to disable CDP on Fast Ethernet interface 5/1:
Switch(config)# interface fastethernet 5/1
Switch(config-if)# no cdp enable
Displaying the CDP Interface Configuration
To display the CDP configuration for an interface, use this command:
This example shows how to display the CDP configuration of Fast Ethernet interface 5/1:
Switch# show cdp interface fastethernet 5/1
FastEthernet5/1 is up, line protocol is up
Encapsulation ARPA
Sending CDP packets every 120 seconds
Holdtime is 180 seconds
Switch#
Monitoring and Maintaining CDP
To monitor and maintain CDP on your device, enter one or more of the following commands:
Command Purpose
Switch(config-if)# [no] cdp enable
Enables CDP on an interface.
Use the no keyword to disable CDP on an interface.
Command Purpose
Switch# show cdp interface [type/number]
Displays information about interfaces where CDP is
enabled.
Command Purpose
Switch# clear cdp counters
Resets the traffic counters to zero.
Switch# clear cdp table
Deletes the CDP table of information about neighbors.
Switch# show cdp
Displays global information such as frequency of
transmissions and the holdtime for packets being
transmitted.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals