1-45
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 1 Product Overview
New and Modified Software Features Supported in Cisco IOS 15.1(1)SG and Cisco IOS XE 3.3SG
http://www.cisco.com/en/US/docs/ios-xml/ios/media_monitoring/configuration/xe-3sg/mm-mediatrace
.html
MLD Group Limits
http://www.cisco.com/en/US/docs/ios-xml/ios/ipv6/configuration/15-1sg/ip6-multicast.html
http://www.cisco.com/en/US/docs/ios-xml/ios/ipv6/configuration/xe-3sg/ip6-multicast.html
Media Services Proxy
http://www.cisco.com/en/US/docs/ios-xml/ios/msp/configuration/15-1sg/med-ser-prxy.html
http://www.cisco.com/en/US/docs/ios-xml/ios/msp/configuration/xe-3sg/med-ser-prxy-xe.html
MSDP MD5 password authentication
http://www.cisco.com/en/US/docs/ios-xml/ios/ipmulti_pim/configuration/15-1sg/imc_msdp.html
http://www.cisco.com/en/US/docs/ios-xml/ios/ipmulti_pim/configuration/xe-3sg/imc_msdp.html
Multicast Address Group Range Support
The Multicast Address Group Range Support feature enhances multicast access control by introducing
the capability to define a global range of multicast groups and channels to be permitted or denied using
the ip multicast group-range command. For more information, see the Cisco IOS IP Multicast
Command Reference at http://www.cisco.com/en/US/docs/ios-xml/ios/ipmulti/command/imc_i2.html.
Named Mode for EIGRP VNETs IPv4
http://www.cisco.com/en/US/docs/ios-xml/ios/iproute_eigrp/configuration/xe-3sg/ire-cfg-eigrp.html
Network Mobility Services Protocol (NMSP) Enhancements
• Custom Location Type
Users can customize the name and value of a switch location using the location custom-location
identifier command.
• Geo Location Type Support
Users can specify the geographical details of a switch location such as latitude, longitude, and
altitude of a switch using the location geo-location identifier command.
• Switch Location Configuration
Users can specify the switch location via ‘host’ identifier on the interface and enter specific location
data under port-location sub-mode using the following commands:
–
location civic-location identifier host
–
location geo-location identifier host
–
location custom-id identifier host
Switch location can contain civic address, custom identifier and GPS location where an individual
location type can be present or absent.
NTPv4 with support for IPv4 and IPv6
http://www.cisco.com/en/US/docs/ios-xml/ios/bsm/configuration/xe-3sg/ip6-ntpv4.html
OSPF Enhanced Traffic Statistics for OSPFv2 and OSPFv3
http://www.cisco.com/en/US/docs/ios-xml/ios/iproute_ospf/configuration/15-1sg/iro-traff-stats.html
To Next Page
Loading...
