Cisco Catalyst 4500 Series - Catalyst 6000;6500 Supervisor Engine Signals and Pinouts; Console Port Mode Switch Operation; Console Port Mode 1 Signaling and Pinouts

Contents
xiii
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Available Power for Catalyst 4500 Series Switches Power Supplies 12-13
Special Considerations for the 4200 W AC and 6000 W AC Power Supplies 12-14
Combined Mode Power Resiliency 12-16
Special Considerations for the 1400 W DC Power Supply 12-18
Special Considerations for the 1400 W DC SP Triple Input Power Supply 12-19
Powering Down a Module 12-19
Power Management for the Catalyst 4948 Switches 12-20
Power Management Modes for the Catalyst 4948 Switch 12-20
IEEE 802.3az Energy Efficient Ethernet 12-20
Determining EEE Capability 12-21
Enabling EEE 12-21
Determining EEE Status 12-22
CHAPTER 13 Configuring Power over Ethernet 13-1
About Power over Ethernet 13-1
Hardware Requirements 13-2
Power Management Modes 13-2
Intelligent Power Management 13-4
Configuring Power Consumption for Powered Devices on an Interface 13-5
Displaying the Operational Status for an Interface 13-6
Displaying all PoE Detection and Removal Events 13-7
Displaying the PoE Consumed by a Module 13-8
PoE Policing and Monitoring 13-12
PoE Policing Modes 13-12
Configuring Power Policing on an Interface 13-13
Displaying Power Policing on an Interface 13-14
Configuring Errdisable Recovery 13-14
Enhanced Power PoE Support on the E-Series Chassis 13-15
Configuring Universal PoE 13-16
CHAPTER 14 Configuring the Catalyst 4500 Series Switch with Cisco Network Assistant 14-1
About Network Assistant 14-2
Community Overview 14-2
Clustering Overview 14-2
Network Assistant-Related Parameters and Their Defaults 14-3
Network Assistant CLI Commands 14-3
Configuring Your Switch for Network Assistant 14-4
(Minimum) Required Configuration 14-4