3-33
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 3 Configuring the Switch for the First Time
Resetting a Switch to Factory Default Settings
When the copying is completed, you can reboot the just-copied Catalyst 4500 series switch image to the
image stored in the bootflash memory with the reload command:
Switch# reload
System configuration has been modified. Save? [yes/no]: no
Proceed with reload? [confirm]
00:06:17: %SYS-5-RELOAD: Reload requested by console. Reload Reason: Reload Command.
To see details about the default parameters set by the erase /all non-default command, see the usage
guidelines for the erase command in the Catalyst 4500 Series Switch Cisco IOS Command Reference.
To Next Page
Loading...
