Cisco Catalyst 4500 Series - Console Port Mode 2 Signaling and Pinouts; Console Port Pinouts (Mode Switch Out); Catalyst 8510 CSR and 8540 CSR Console Port Pinouts; DB-25 Console Port Pinouts

Contents
xvi
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
CHAPTER 17 Configuring Layer 2 Ethernet Interfaces 17-1
About Layer 2 Ethernet Switching 17-1
Layer 2 Ethernet Switching 17-2
Switching Frames Between Segments 17-2
Building the MAC Address Table 17-2
VLAN Trunks 17-3
Layer 2 Interface Modes 17-3
Default Layer 2 Ethernet Interface Configuration 17-4
Layer 2 Interface Configuration Guidelines and Restrictions 17-4
Configuring Ethernet Interfaces for Layer 2 Switching 17-5
Configuring an Ethernet Interface as a Layer 2 Trunk 17-5
Configuring an Interface as a Layer 2 Access Port 17-7
Clearing Layer 2 Configuration 17-8
CHAPTER 18 Configuring SmartPort Macros 18-1
About SmartPort Macros and Static SmartPort 18-1
Configuring SmartPort Macros 18-2
Passing Parameters Through the Macro 18-3
Macro Parameter Help 18-3
Default SmartPort Macro Configuration 18-4
cisco-global 18-4
cisco-desktop 18-4
cisco-phone 18-5
cisco-router 18-5
cisco-switch 18-5
SmartPort Macro Configuration Guidelines 18-6
Creating SmartPort Macros 18-8
Applying SmartPort Macros 18-9
cisco-global 18-10
cisco-desktop 18-11
cisco-phone 18-11
cisco-switch 18-12
cisco-router 18-13
Displaying SmartPort Macros 18-14
Configuring Static SmartPort Macros 18-14
Default Static SmartPort Configuration 18-14
Static SmartPort Configuration Guidelines 18-15
Applying Static SmartPort Macros 18-15