EasyManua.ls Logo

Cisco Catalyst 4500 Series - Page 473

Cisco Catalyst 4500 Series
1610 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15-25
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 15 Configuring VLANs, VTP, and VMPS
VLAN Membership Policy Server
To define the primary and secondary VMPS on a Catalyst 4500 series switch, perform this task:
This example shows how to define the primary and secondary VMPS devices:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# vmps server 172.20.128.179 primary
Switch(config)# vmps server 172.20.128.178
Switch(config)# end
Note You can configure up to four VMPS servers using this CLI on the VMPS client.
Switch# show vmps
VQP Client Status:
--------------------
VMPS VQP Version: 1
Reconfirm Interval: 60 min
Server Retry Count: 3
VMPS domain server: 172.20.128.179 (primary, current)
172.20.128.178
Reconfirmation status
---------------------
VMPS Action: No Dynamic Port
Configuring Dynamic Access Ports on a VMPS Client
To configure a dynamic access port on a VMPS client switch, perform this task:
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# vmps server
{ipaddress | hostname} primary
Specifies the IP address or hostname of the switch acting as the
primary VMPS server.
Step 3
Switch(config)# vmps server
{ipaddress | hostname}
Specifies the IP address or hostname of the switch acting as a
secondary VMPS server.
Step 4
Switch(config)# end
Returns to privileged EXEC mode.
Step 5
Switch# show vmps
Verifies the VMPS server entry.
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# interface interface
Enters interface configuration mode and specifies the port to be
configured.
Step 3
Switch(config-if)# switchport mode
access
Sets the port to access mode.
Step 4
Switch(config-if)# switchport access
vlan dynamic
Configures the port as eligible for dynamic VLAN access.
Step 5
Switch(config-if)# end
Returns to privileged EXEC mode.
Step 6
Switch# show interface interface
switchport
Verifies the entry.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Related product manuals