liii
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Preface
This preface describes who should read this document, how it is organized, and its conventions. The
preface also tells you how to obtain Cisco documents, as well as how to obtain technical assistance.
Audience
This guide is for experienced network administrators who are responsible for configuring and
maintaining Catalyst 4500 series switches.
Organization
This guide is organized into the following chapters:
Chapter Title Description
Chapter 1 Product Overview Presents an overview of the Cisco IOS software for
the Catalyst 4500 series switches.
Chapter 2 Command-Line Interfaces Describes how to use the CLI.
Chapter 3 Configuring the Switch for the
First Time
Describes how to perform a baseline configuration
of the switch.
Chapter 4 Administering the Switch Describes how to administer the switch.
Chapter 5 Configuring the Cisco IOS
In-Service Software Upgrade
Process
Describes how to configure the IOS ISSU process
on the switch.
Chapter 6 Configuring the Cisco IOS XE In
Service Software Upgrade Process
Describes how to configure the IOS XE ISSU
process on the switch.
Chapter 7 Configuring Interfaces Describes how to configure non-layer-specific
features on Fast Ethernet, Gigabit Ethernet, and
10-Gigabit Ethernet interfaces.
Chapter 8 Checking Port Status and
Connectivity
Describes how to check module and interface status.
To Next Page
Loading...
