Cisco Catalyst 4500 Series - Page 840

38-4
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 38 Configuring Policy-Based Routing
About Policy-Based Routing
PBR Route-Map Processing Logic Example
Consider a route-map called rm-test defined as follows:
access-list 101 permit tcp host 61.1.1.1 host 133.3.3.1 eq 101
access-list 102 deny tcp host 61.1.1.1 host 133.3.3.1 eq 102
access-list 2102 permit tcp host 61.1.1.1 host 133.3.3.1 eq 102
access-list 104 deny tcp host 61.1.1.1 host 133.3.3.1 eq 104
access-list 2104 permit tcp host 61.1.1.1 host 133.3.3.1 eq 104
access-list 105 permit tcp host 61.1.1.1 host 133.3.3.1 eq 105
route-map rm-test permit 21
match ip address 101
set ip next-hop 21.1.1.1
!
route-map rm-test permit 22
match ip address 102
set ip next-hop 22.2.2.1
!
route-map rm-test permit 23
match ip address 101 2102
set interface vlan23
!
route-map rm-test deny 24
match ip address 104
set ip next-hop 24.4.4.1
!
route-map rm-test deny 25
match ip address 105
set ip next-hop 25.5.5.1
!
route-map rm-test permit 26
match ip address 2104
set ip next-hop 26.6.6.1
• TCP packet from 61.1.1.1 to 133.3.3.1 with destination port 101
– Matches ACL 101 in sequence #21.
– PBR is switched through next-hop 21.1.1.1.
Note ACL 101 is also matched in sequence #23, but the processing doesn't reach that point
• TCP packet from 61.1.1.1 to 133.3.3.1 with destination port 102
– In sequence #21, the ACL 101 action denies this packet (because all ACLs have an implicit
deny). Processing advances to sequence #22.
– In sequence #22, ACL 102 matches TCP port 102, but the ACL action is deny. Processing
advances to sequence #23.
– In sequence #23, ACL 2102 matches TCP port 102, and the ACL action is permit.
– Packet is switched to output interface VLAN 23.