EasyManua.ls Logo

Cisco Catalyst 4500 Series - Page 912

Cisco Catalyst 4500 Series
1610 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
40-48
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Chapter 40 Configuring Quality of Service
Configuring Auto-QoS
class-map match-all AutoQos-4.0-Scavenger-Classify
match access-group name AutoQos-4.0-ACL-Scavenger
class-map match-all AutoQos-4.0-Default-Classify
match access-group name AutoQos-4.0-ACL-Default
! for interfaces with video devices
class-map match-any AutoQos-4.0-VoIP
match dscp ef
match cos 5
class-map match-all AutoQos-4.0-Broadcast-Vid
match dscp cs5
class-map match-all AutoQos-4.0-Realtime-Interact
match dscp cs4
class-map match-all AutoQos-4.0-Network-Ctrl
match dscp cs7
class-map match-all AutoQos-4.0-Internetwork-Ctrl
match dscp cs6
class-map match-any AutoQos-4.0-Signaling
match dscp cs3
match cos 3
class-map match-all AutoQos-4.0-Network-Mgmt
match dscp cs2
class-map match-any AutoQos-4.0-Multimedia-Conf
match dscp af41
match dscp af42
match dscp af43
class-map match-any AutoQos-4.0-Multimedia-Stream
match dscp af31
match dscp af32
match dscp af33
class-map match-any AutoQos-4.0-Transaction-Data
match dscp af21
match dscp af22
match dscp af23
class-map match-any AutoQos-4.0-Bulk-Data
match dscp af11
match dscp af12
match dscp af13
class-map match-all AutoQos-4.0-Scavenger
match dscp cs1
The class maps are intended to identify control and data (bearer) voice traffic for either an Layer 2 or
Layer 3 interface.
The 2 Input policy maps, one for matching DSCP and one for matching COS, where DSCP and COS are
set to an assigned qos-group used in outbound policy-maps are as follows:
policy-map AutoQos-VoIP-Input-Dscp-Policy
class AutoQos-VoIP-Bearer-Dscp
set qos-group 46
class AutoQos-VoIP-Control-Dscp26
set qos-group 26
class AutoQos-VoIP-Control-Dscp24
set qos-group 24
! Note: For COS, Control traffic only has a single COS value of 3 (versus DSCP which has 2
values to match). So, only 2 class-maps instead of 3 like above.
policy-map AutoQos-VoIP-Input-Cos-Policy
class AutoQos-VoIP-Bearer-Cos
set qos-group 46
class AutoQos-VoIP-Control-Cos
set qos-group 24

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Related product manuals