Cisco D9824 - Setting up the Channel Selections

Setting up Input Information
179
Setting up the Channel Selections
Note: If the unit is in a disaster recovery or NIT retune recovery mode, an error
message is displayed, informing you that any changes made to the page will
interrupt the disaster recovery or NIT retune process. The error message appears
when you load, refresh, or apply changes to the page. For more information on NIT
retune, see NIT Retune Recovery (on page 10). For more information on disaster
recovery, see Disaster Recovery (on page 7).
1 From the user interface of the D9824, choose Input > Channel Selection. The
Channel Selection page is displayed.
2 From the PE1 to PE32 drop-down lists, choose a channel number for up to 32
program entries.
3 Click Apply.