Chapter 5 Web GUI Setup and Monitoring
Setting up the BISS Mode
1 From the user interface of the D9824, choose Input > BISS. The BISS page is
displayed.
2 Choose the Basic Interoperable Scrambling System for the receiver (Mode 1 or
Mode E) from the BISS Mode drop-down list. All channels assigned to the PE
identified as BISS CA-controlled in the PMT will be decrypted.
3 If you chose BISS Mode 1, enter a fixed 12-character BISS Mode-1 session word in
the BISS Mode-1 Session Word field. Once entered it cannot be viewed and it is
only displayed as asterisks (*). Contact your program provider for the session
word.
4 If you chose BISS Mode E, enter the 16-character BISS Mode-E encrypted session
word in the BISS Mode-E Encrypted Session Word field and the 14-character
BISS Mode-E injected ID in the BISS Mode-E Injected ID field. Once entered,
neither of these values can be viewed and it is only displayed as asterisks.
Contact your program provider for the respective session word and/or injected
ID.
5 Click Apply.
To Next Page
Loading...
Need help?
General
