Setting the DPM Mode
A program can be set to one of three Digital Program Mapping (DPM) modes, either
Drop, Pass or Map respectively. For more information, see TS Out - DPM (on page
111) .
Removes the service and its associated PMT reference
from the transport output.
Permits the source content and PMT reference to appear
in the transport output with the same references unless
the source material is mapped on another PE.
Provides the flexibility to define all the outgoing PID
numbers for a PE, including those not currently on
transmission.
1 Press MENU to display the Main Menu.
2 Press to move to the Setup menu. Press SELECT.
3 Press five times to move to the Outputs menu. Press SELECT.
4 Press to move to the TS Out menu. Press SELECT.
5 Press to move to the DPM menu. Press SELECT.
6 Press SELECT to access the Global menu.
7 Press SELECT to choose ASI for Resync All. Press and then press SELECT to
continue.
8 Press MENU. Press to move to the ASI menu. Press SELECT. Verify the PE1
”InCh” and ”OutCh” programs.
9 Press three times to choose Act. Press SELECT. Use to select the DPM
action for the PID associated with the PE. Press SELECT. Press APPLY. Press
SELECT to save the changes.
10 Press MENU six times to return to the start-up screen.
To Next Page
Loading...
Need help?
General
