Cisco D9824 - Assigning a Program Channel to a PE (Program Entry)

Assigning a Program Channel to a PE (Program Entry )
15
Assigning a Program Channel to a PE (Program
Entry)
1 At the start-up screen, PE1 is initially displayed.
2 You can assign up to 32 program entries by pressing the ADV key to select PE1.
3 Use the keys to scroll through the available program entries.
4 Press ADV again to select the channel number.
5 Use the keys to scroll through the available program channels or directly
enter the channel number using the 0 to 9 keys; press SELECT to save the
channel selection.