Cisco D9824 User Manual

Setting up Audio and Video Information
205
Setting up Cue Tones
1 From the user interface of the D9824, choose Audio & Video > Cueing > Cue
Tone. The Cue Tone page is displayed.
2 The Sequence Number lists the tone sequences. The receiver supports up to 16
tone sequences. You can configure the state, tones, mode, and delay for each tone
sequence.
3 Choose the current state of the tone sequence from the Sequence State drop-
down list (Enabled or Disabled). If disabled, no cue tone is output.
4 In the Sequence Tones field, set the three digit tone sequence (1 to 999).
5 Choose the tone from the Sequence Mode drop-down list.
Choose * for start tone, # for the end tone, and */# for the start and end tones.
The end tone is signaled after waiting the time specified in Sequence Delay.
6 If the Sequence Mode was set to */# (Start/Stop), enter the sequence delay, in
seconds, between the start and stop sequences in the Sequence Delay field. You
can enter a value in the range from 1 to 255. The default is 30.
7 Click Apply.

Cisco D9824 Specifications

General

Brand	Cisco
Model	D9824
Category	Receiver
Language	English