Cisco D9824 User Manual

Configuring Transport Stream Information
221
Configuring the MPEGoIP Output
1 From the user interface of the D9824, choose Transport Stream > MPEG over IP
Output. The MPEG over IP Output page is displayed.
Note: Any changes made to the MOIP DPM values will automatically change the
Mode Status to Edited by User.
2 Choose the MOIP output rate control from the Rate Control drop-down list. The
following table describes the affect each of the settings has on the output bit rate:

Cisco D9824 Specifications

General

Brand	Cisco
Model	D9824
Category	Receiver
Language	English