Configuring System Settings
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be
functional.
5 If current warning is enabled, from the Trap drop-down list, choose Yes to send
the SNMP trap message when the warning is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the warning is disabled (Enb is set to No).
6 If current warning is enabled, from the Relay drop-down list, choose Yes to
trigger the rear panel alarm relay when the warning is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the warning is disabled (Enb is set to No).
7 Click Apply.
To Next Page
Loading...
