Cisco D9824 - Page 362

Chapter 6 Service and Maintenance
340
Warning
Message
Type
Message
Cause/Remedy
Description
ID
MoIPI Port<n>:
FEC2 Loss (only
available for
D9824 with
LX155 FPGA)
Clear
FEC ROW:
stream not
configured
–
–
93101
93103
MoIPI Port<n>:
FEC2 Loss (only
available for
D9824 with
LX155 FPGA)
Clear
FEC ROW:
configured
stream present
–
–
93101
93103
MPoIPI: DJ HW
failure (only
available for
D9824 with
LX155 FPGA)
Set
De-jittering
Engine failure
(overflow,
underflow or
HW error)
Cause: De-jittering
hardware failure.
Remedy: Software-
controlled reset of de-
jittering block may help.
But in most cases, the
problem is triggered by
the stream originator or
the network conditions
and cannot be fixed in
the decoder.
The de-jittering block
has an overflow,
underflow, or other
hardware problems.
93104
MPoIPI: DJ HW
failure (only
available for
D9824 with
LX155 FPGA)
Clear
Need two active
TS streams for
proper error
detection
–
–
93104
MPoIPI: DJ HW
failure (only
available for
D9824 with
LX155 FPGA)
Clear
Fault Cleared: No
errors
–
–
93104
Hardware
Platform
Set
Non-matching
HW Platform.
APP: <D9859 |
D9854/58/24>,
HW: <TMB2 |
HDR/TMB/HDR
2>
Cause: A non-matching
application is loaded
through CDT download
or FLASH
programming.
Remedy: Replace the
non-matching
application and then
reboot the IRD.
The D9859 application
is running on the
D9854/D9858/D9824
platform or the
D9854/D9858/D9824
application is running
on the D9859
application.
94000
Hardware
Platform
Clear
–
Matching Hardware
Platform detected.
–
94000