Cisco D9858 User Manual

Chapter 4 Front Panel Operation
98
Menu Item
Description
Parameters
MOIP
Selects the transport protocol to
be used for the output stream.
RTP or UDP
Min IP/s
This selects the minimum
number of IP packets per
second.
0, 2 to 1000
TOS (Type Of
Service)
This sets the quality of service.
0 to 255
TTL (Time To Live)
This sets the hop limit of the
packet's lifespan.
0 to 255
DestAddr
Enter the unicast (valid host IP
only) or multicast destination
IP address.
Unicast: valid host IP
Multicast: IP in range of 224.0.0.0 to
239.0.0.0
Note: We recommend that you do not
use multicast IP addresses reserved
by the Internet Assigned Numbers
Authority (IANA).
UDPPort
This selects the destination port
number.
1 to 65534
Note: If you selected RTP for MOIP,
you must select an even destination
port number.
Note: We recommend that you do not
use destination UDP ports reserved
by the IANA.
SrcPort
This selects the source UDP
port number.
0 to 65535
Note: Set the SrcPort to 0 to use the
default source UDP port (49162).
Send SAP
This selects whether to send
Session Announcement
Protocol messages.
None or RFC2327
SAP Multicast
Address
This is the IP address where the
SAP announcements are sent, if
required.
We recommend that you do not
change the default IP address
(224.2.127.54).
SAP Port
This is the UDP port where the
SAP announcements are sent, if
required.
1 to 65534
Note: We recommend that you do not
change the default SAP port 9875.
SAP ID
Describes the SAP output
stream name source.
User String or SDT Channel
SAP User Str
Provides the SAP user string.
Up to 31 characters

Cisco D9858 Specifications

General

Brand	Cisco
Model	D9858
Category	Receiver
Language	English