Name: Cisco D9858
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Configuring Transport Stream Information

189

Configuring Transport Stream Information

Configuring the ASI Output

1 From the user interface of the D9858, choose Transport Stream > ASI Output.

The ASI Output page is displayed.

Note: After you make any changes, a successfully updated (session open)

message appears. The changes are displayed, but not saved. You must click

Apply to save and apply the changes.

Note: Any changes made to the ASI DPM values will automatically change the

Mode Status to Edited by User.

2 Choose the output rate control from the Rate Control drop-down list. The

following table describes the affect each of the settings has on the output bit rate:

Questions and Answers:

Need help?

Do you have a question about the Cisco D9858 and is the answer not in the manual?

Cisco D9858 Specifications

General