Appendix B
Default Settings and Lock Levels
Factory Default Settings and Lock Levels
The D9858 Advanced Receiver Transcoder is factory configured with default settings
unless you have requested a custom factory configuration.
The following table lists the lock levels available for protecting your transcoder and
its settings against unauthorized use or modification:
All settings are unlocked (transcoder lockout disabled)
All settings are unlocked except Factory Reset,
Password options and transcoder parameters.
All settings are unlocked except RF and ASI Input
Tuning parameters.
All settings locked (access via password only), except IP
address and RF power.
All settings locked (can be changed via PNC uplink
signal only)
If a change made to the current Lock Level setting is not saved, the previously saved setting
is restored.
Note: The user cannot select NONE as a Lock Level.
Administration
Old Pwd, New Pwd, Confirm
Pwd