Cisco D9858 User Manual

Versions Menu
131
Menu Item
Description
FPGA Version,
Select, Erase
FPGA Version - Select between all versions of the FPGA code
loaded on the current unit.
Select - Select and then scroll to Yes to reboot the unit and load
the selected FPGA code. You will be prompted to continue or
abort this operation.
Note: Selecting an FPGA code will cause the unit to reboot
and interrupt service.
Erase - Select to erase the selected FPGA code. You will be
prompted continue or abort this operation. You cannot erase
the safe FPGA code or the current FPGA code. While an FPGA
code is being erased, the busy indicator will appear. You
cannot erase another FPGA code until it is complete.
Note: You cannot reboot or remove applications during a
download or erase. You must stop the download first. For
more information on aborting the download, see Setup Menu:
Admin (on page 58).
Transcoder Versions
The following are the version numbers applicable to the Transcoder printed circuit
board.
Menu Item
Description
Host Root FS, Host
Kernel
Indicates the Host Root FS and Kernel version numbers.
Host Boot
Indicates the Host Boot version number.
Interface
Indicates the Interface version number.
FPGA
Indicates the Field Programmable Gate Array (FPGA)
version number.
CPLD
Indicates the CPLD version number.
MPEG2 FW
Indicates the MPEG-2 FW version number.
H.264 App Curr 1,
H.264 App Curr 2
Indicates the current H.264 transcoder path 1 and H.264
transcoder path 2 application version number.
H.264 App Safe 1 and
H.264 App Safe 2
Indicates the factory loaded H.264 transcoder path 1 and
H.264 transcoder path 2 application version number.
H.264 Boot 1 and
H.264 Boot 2
Indicates the H.264 transcoder path 1 and H.264 transcoder
path 2 boot version number.

Cisco D9858 Specifications

General

Brand	Cisco
Model	D9858
Category	Receiver
Language	English