Configuring Transport Stream Information
Configuring the MPEGoIP Output
1 From the user interface of the D9858, choose Transport Stream > Transport
Handling > MPEG over IP Output. The MPEG over IP Output page is
displayed.
Note: Any changes made to the MOIP DPM values will automatically change the
Mode Status to Edited by User.
2 From the Rate Control drop-down list, choose the DPM output rate control. The
following table describes the affect each of the settings has on the output bit rate:
The output rate follows that set by the uplink. This setting can be
used if the signal source is ASI. If Null Packet Insertion is set to
Yes, the output bit rate is the same as the input rate (including all
the null packets). If Null Packet Insertion is set to No, the output
rate is equal to the payload rate of the transport stream to be
encapsulated, and in most cases, it will be lower than the overall
input rate.
To Next Page
Loading...
Need help?
General
