Chapter 5 Web GUI Setup and Monitorin g
Setting up IP Routing Information
1 From the user interface of the D9858, choose System Settings > IP Settings > IP
Routing. The IP Routing page is displayed.
2 From the RIP drop-down list, choose Enable to enable the Routing Information
Protocol (RIP). Otherwise, choose Disable. This is a standard protocol for
automatic unicast route discovery. If enabled, the routing information is
displayed in the Installed Unicast Routes table.
3 Click Apply.
4 In the Static Unicast Routing table, you can set the static unicast routing
information used to by MPEGoIP and MPE outputs to send data packets. It can
also be used to find hosts behind a router (for example, an FTP server, a syslog
server, or an NTP server).
To add a unicast route:
a Click Add Row.
b In the Destination IP Address field, enter the IP address that sets the
destination for the unicast route.
c In the Mask field, enter the number of CIDR (Classless Inter-Domain
Routing) bits in the network mask (8 to 30).
To Next Page
Loading...
Need help?
General
