DPM Default Settings for Different Output Modes
DPM Default Settings for Different Output Modes
The DPM parameters are preset to default settings for each DPM Output Mode.
The default settings for particular Output modes have been preset to optimize the
output when either PID mapping or transcoding is required. If the DPM parameters
are changed to values which switch the transcoder to Full DPM Control, the
transcoder may enter a condition where conflicts in the settings may occur, which
may require manual manipulation of the DPM or output parameters to obtain the
desired output.
The fields labeled “Any” in the table below, are not used, in which case, the Output
Mode will not change if the parameter is changed. However, if you change any of
the other parameters listed in the table for the MAP or Transcoding output modes,
the Output Mode will change to Full DPM Control.
To Next Page
Loading...
Need help?
General
