Cisco D9858 - Input and Channel Setup

Setup Menu
123
Menu Item
Description
Parameters
Audio(DVBS Marg)
Restore
Audio(DVBS2 Marg)
Restore
Sets the DVB-S and DVB-S2
Carrier to Noise margins, in dB,
above the audio outputs that
will be restored.
The receiver uses these
thresholds to determine when to
restore the audio after it has
been muted.
-30.0 to 30.0
This setting must be below the
respective Cutoff value.
The default is 0.1.
Note: Muting Control must be set
to Enable for these settings to be
active.
The following displays the Audio Default C/N Margin Relationship
Restore Defaults
Select to restore the default
muting thresholds.
Muting Control
Select whether to enable or
disable muting cutoffs.
If disabled, all the other settings
are ignored.
Enable or Disable.
The default is Enable.
Setup Menu: DR
To view the DR (Disaster Recovery) menu from the Main menu, press the RIGHT
arrow key once and then the SELECT key to reach the Setup menu. Then press the
LEFT arrow key once and the SELECT key to view the DR menu.
The DR menu allows you to set up the disaster recovery parameters. For more
information on disaster recovery, see Disaster Recovery (on page 7).
Each parameter is described below. The menu has the following structure: