Chapter 5 Web GUI Setup and Monitorin g
Transmits the PSI tables for the mapped program even if the
program does not exist in the input stream.
All Ch is only valid if the PAT, NIT, SDT and PMT are set to
Regenerate.
6 If the PSI Table Output Option is set to Ctrl by Table, choose the regeneration
rate for those PSI tables being regenerated from the SI Regeneration Option
drop-down list. This parameter is only used if Remapping Control is set to None.
The following table describes each PSI rate:
Matches the generated PSI tables' output rate to the incoming rate.
Transmits the generated PSI tables on the longest intervals that are
allowed by MPEG standard.
Transmits the generated PSI tables based on PowerVu standard
intervals.
7 From the PSI Table Output Option drop-down list, choose the action to perform
on the PSI tables for the output stream. The following table describes each
option:
Transmits the incoming PSI Tables as is; does not modify the
content and rate. The SI Regeneration Option and table settings are
ignored.
Does not transmit any PSI Tables. The SI Regeneration Option and
table settings are ignored.
The operator can click Table Options to select the table specific
output mode for each table.
To Next Page
Loading...
Need help?
General
