Configuring System Settings
6 From the PHY Mode drop-down list, choose the speed and duplex type of the
interface. Choose Auto for PHY to negotiate speed and duplex with other
devices on the network, or select 10 HD (half-duplex), 10 FD (full-duplex), 100
HD, 100 FD, or 1000 FD to lock into a fixed mode. Otherwise, choose N/A. The
default is Auto.
7 Click Save.
Protocol Control Settings
The Protocol Control area allows you to control remote access protocols to the IRD
(Telnet, SSH, HTTP, HTTPS (via HTTP secure setting), and SNMP).
1 From the Telnet, SSH, HTTP, and SNMP drop-down list, choose Enable
(default) to allow Telnet, Secure Shell, HTTP, and/or SNMP connections.
Otherwise, select Disable.
The following lists the associated port numbers for each protocol:
HTTPS (via HTTP secure
setting)
For information on accessing TCP/IP services, see Accessing TCP and UDP
Services (on page 75).
The HTTP has an additional Secure setting for an encrypted access to the
webserver (HTTPS).
a From the HTTP drop-down list, choose Secure. A confirmation message that
you will be logged out automatically is displayed.
To Next Page
Loading...
Need help?
General
