Cisco D9858 - Control Interfaces and Power Specifications

321
Warning
Message
Type
Message
Cause/Remedy
Description
ID
Restore Failure
Reason
Set
Not Accepted
Cause: Import file is
either for a different
product or the structure
was not compatible with
this unit.
Remedy: Verify that the
correct import file is
being used and was
created by this product.
Verify that the file
structure has not been
corrupted. If the
problem persists, notify
Cisco Services.
Import file was
rejected and import
did not occur
89100
Restore Failure
Reason
Set
Bad Content
Cause: Import file may
be corrupted, or from a
different version of
application software.
Remedy: Verify that the
correct import file is
being used and was
created by this product.
Verify that the file
structure has not been
corrupted. If the
problem persists, notify
Cisco Services.
Item in import file is
not valid for this
software and import
did not occur
89100
MPoIP Bitrate
Port #<n>
Set
Total configured
output is
marginal or too
high
Cause: The aggregated
MPEG over IP
bandwidth on Port <n>
is too high.
Remedy: Re-configure
the output rate of the
stream(s) to be within
90% of the link speed on
Ethernet port <n>.
Configured MPEG
over IP bandwidth is
very close or higher
than the Ethernet port
<n> link speed. This
condition can trigger
the actual MPoIP
overflow.
92000
92100
MPoIP Bitrate
Port #<n>
Clear
Total configured
output is normal
–
–
92000
92100
MPoIP Bitrate
Port #<n>
Clear
Inactive port,
monitoring
stopped
–
–
92000
92100