Cisco D9858 User Manual

Chapter 4 Front Panel Operation
68
Menu Item
Description
Parameters
22kHz
For dual band applications, select whether to
transmit the 22 kHz tone Local Oscillator
control signal of RF1.
On, Off, or Auto.
Auto uses the crossover
frequency to determine if
the tone is transmitted.
Tune Mode
Custom
This menu is where you set up your custom properties. Select the channel to set up
and then edit it.
Menu Item
Description
Parameters
Services List Mode
If using custom tune mode,
select which tables are required
for tuning.
Rigorous - Requires all service list tables
to be present to acquire the signal.
Degraded - Requires any service list
table to be present to acquire the signal.
BAT
This is not supported in the
current release.
No
NIT
If using custom tune mode,
select whether to use the
Network Information Table
(NIT) when creating the service
list.
Yes or No
SDT
If using custom tune mode,
select whether to use the Service
Description Table (SDT) when
creating the service list.
Yes or No
PAT
If using custom tune mode,
select whether to use the
Program Association Table
when creating the service list.
Yes or No
Frequency Tuning
If using custom tune mode,
select whether to use the NIT to
tune to other transports, or to
force the tuning to user
configuration settings.
NIT - The transcoder can change tuning
parameters to use all transports available
in the NIT.
User Cfg - The transcoder is forced to
use the user selected tuning parameters.

Cisco D9858 Specifications

General

Brand	Cisco
Model	D9858
Category	Receiver
Language	English