Cisco Firepower 4100

DescriptionField
Duplicate WWN
Invalid other princ epp req received
Isolated due to unknown reason
Incomplete tunnel configuration
Hardware programming failed
No route to tunnel destination address
Module removed
MTU allocation failed
All parameters have not been configured
SFP is not inserted
Transceiver is not inserted
SFP is not Cisco certified
Transceiver is not Cisco certified
Bit error rate threshold exceeded
Link failure link reset
Link failure port initialization failed
ELP failure, all zero peer WWN received
Isolation due to preferred path
FC redirect isolation
Port activity license not available
SDM isolation
FCID allocation failed
Externally disabled
Authorization pending
Hot standby in bundle
Channel error-disabled
Port capabilities not known
Mismatch in source and transport VRF
Forward referencing transport VRF
two tunnel interface with same configuration is not allowed
Too many link flaps in a short interval
Primary vlan is down.
VRF Unusable
Cisco Firepower 4100/9300 FXOS Command Reference
288
S Commands
show interface brief (connect fxos)