Cisco Firepower 4100 Command Reference

Additional InformationCommand
Configure the system. Enter config ? for options
vnic – Configure specified VNIC
memory – Configure memory monitor
disk – Configure disk monitor
process – Configure process cpu monitor
maxRestart – Configure maximum restarts CSP. 0 shall Disable feature.
Default 8
restartTimeInter – Configure time in seconds to block all CSPs from starting
if server restarts maxRestart in this interval. Default 1200
restartCounters – To reset the restart_count
coredump – config coredump {...}
turboBoost – config turboBoost {...}
config
Terminal settings. Enter terminal ? for options
enable – terminal length enable
disable – terminal length disable
terminalLength
Ping a host to check reachability
host
ping
Look up an IP address or host name with the DNS servers
host
nslookup
Trace the route to a remote host
host
traceroute
Connect to specific csp console (asa, etc)
appname apphost
connect
Cisco Firepower 4100/9300 FXOS Command Reference
416
connect shell Commands
connect module: Command List

Cisco Firepower 4100 Specifications

General

Brand	Cisco
Model	Firepower 4100
Category	Firewall
Language	English