Cisco IE 4000 Software Configuration Guide

127
Cisco Systems, Inc. www.cisco.com
Configuring PROFINET
Restrictions for Configuring PROFINET
Cisco IE series switches support PROFINET I/O, RT but not IRT (isochronous real-time).
Information About Configuring PROFINET
PROFINET is the PROFIBUS International (PI) open Industrial Ethernet Standard that uses TCP/IP and IT standards for
automation control. PROFINET is particularly useful for industrial automation systems and process control networks,
in which motion control and precision control of instrumentation and test equipment are important. It emphasizes
data exchange and defines communication paths to meet speed requirements. PROFINET communication is scalable on
three levels:
 Normal non-real-time communication uses TCP/IP and enables bus cycle times of approximately 100 ms.
 Real-time communication enables cycle times of approximately 10 ms.
 Isochronous real-time communication enables cycle times of approximately 1 ms.
PROFINET I/O is a modular communication framework for distributed automation applications. PROFINET I/O uses cyclic
data transfer to exchange data, alarms, and diagnostic information with programmable controllers, input/output (I/O)
devices, and other automation controllers (for example, motion controllers).
PROFINET I/O recognizes three classes of devices:
 I/O devices
 I/O controllers
 I/O supervisors

Cisco IE 4000 Specifications

General

Product Type	Switch
Form Factor	DIN Rail Mountable
MAC Address Table Size	8000
Jumbo Frame Support	9216 bytes
Operating Temperature	-40°C to 70°C
Mean Time Between Failures (MTBF)	Over 500, 000 hours
Memory	256 MB DRAM
Mounting	DIN Rail, Wall
Certifications	EN 50121-4
Ports	8 x 10/100Base-TX Ethernet Ports