845
Configuring IP Unicast Routing
Configuring EIGRP
DETAILED STEPS
Enter the show ip eigrp neighbor detail privileged EXEC command from the distribution router to verify the configuration.
EXAMPLE
In the following example, the eigrp stub command is used to configure the router as a stub that advertises connected
and summary routes:
Switch(config)# router eigrp 1
Switch(config-router)# network 10.0.0.0
Switch(config-router)# eigrp stub
Monitoring and Maintaining EIGRP
You can delete neighbors from the neighbor table. You can also display various EIGRP routing statistics.
Command Purpose
1. configure terminal Enter global configuration mode.
2. router eigrp 1 Configure a remote or distribution router to run an EIGRP
process and enter router configuration mode.
3. network network-number Associate networks with an EIGRP routing process.
4. eigrp stub [receive-only |
connected | static | summary]
Configure a remote router as an EIGRP stub router. The
keywords have these meanings:
Enter receive-only to set the router as a receive-only
neighbor.
Enter connected to advertise connected routes.
Enter static to advertise static routes.
Enter summary to advertise summary routes.
5. end Return to privileged EXEC mode.
6. show ip eigrp neighbor detail Verify that a remote router has been configured as a stub router
with EIGRP. The last line of the output shows the stub status of
the remote or spoke router.
7. copy running-config
startup-config
(Optional) Save your entries in the configuration file.
To Next Page
Loading...
