948
Configuring IPv6 Unicast Routing
Configuring IPv6
Switch(config-if)# ipv6 rip cisco enable
Configuring OSPF for IPv6
You can customize OSPF for IPv6 for your network. However, the defaults are set to meet the requirements of most
customers and features.
Be careful when changing the defaults for IPv6 commands. Doing so might adversely affect OSPF for the IPv6 network.
BEFORE YOU BEGIN
Before you enable IPv6 OSPF on an interface, you must:
Enable routing by using the ip routing global configuration command.
Enable the forwarding of IPv6 packets by using the ipv6 unicast-routing global configuration command.
Enable IPv6 on Layer 3 interfaces on which you are enabling IPv6 OSPF.
To Next Page
Loading...
