Name: Cisco IE 4000
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

761

Configuring IPv6 MLD Snooping

EXAMPLE

This example shows how to enable MLD Immediate Leave on VLAN 130:

Switch# configure terminal

Switch(config)# ipv6 mld snooping vlan 130 immediate-leave

Switch(config)# exit

Configuring MLD Snooping Queries

When Immediate Leave is not enabled and a port receives an MLD Done message, the switch generates MASQs on the

port and sends them to the IPv6 multicast address for which the Done message was sent. You can optionally configure

the number of MASQs that are sent and the length of time the switch waits for a response before deleting the port from

the multicast group.

Other manuals for Cisco IE 4000

Questions and Answers:

Need help?

Do you have a question about the Cisco IE 4000 and is the answer not in the manual?

General

Product Type	Switch
Form Factor	DIN Rail Mountable
MAC Address Table Size	8000
Jumbo Frame Support	9216 bytes
Operating Temperature	-40°C to 70°C
Mean Time Between Failures (MTBF)	Over 500, 000 hours
Memory	256 MB DRAM
Mounting	DIN Rail, Wall
Certifications	EN 50121-4
Ports	8 x 10/100Base-TX Ethernet Ports